23
Check if the power cord is connected properly.
Check if the hopper is assembled properly. Check if the hopper’s lid is assembled properly.
Check if the product is assembled in proper order. Refer to p. 08~11 (How to Assemble).
The juicer would not operate properly when the hopper is not assembled properly.
If the trouble still persists after taking said measures, please contact our customer center for further
instruction.
Have you in heavy loads or large pieces of ingredients into the appliance?
If the issue is not resolved after following the above process, please contact your local Customer
Service Center.
These are molding marks resulting from the normal manufacturing process.
This is normal and there is no problem for use.
The chamber set cannot be to the main body when the lever is set to ◯.
of the ingredient Check the [MAX], [ ] icon on the side of the hopper and make sure the
It is possible that there is pulp remaining inside. Set the lever to (Half Open), turn the power dial to
and repeat this twice or three times. You will be able to open the chamber lid easily afterwards.
cannot open the lid then please contact our Customer Service Center for further instructions.
The chamber can shake slightly due to the rotation of the motor.
the characteristics of the ingredients (hardness and toughness). This is a normal as the movement is
caused by the rotating screw and is not considered as a trouble. It may seem that it is shaking more
the friction between ingredients depending on the characteristics of the ingredients (i.e. carrot/
for operation.
Before Requesting for Repair
To Next Page
Loading...
Need help?
General
