10
After the product stops operating completely,
unplug the power cord with your dry hands. The
motor is still slowing down after the appliance
is turned off so wait about 3 seconds before
separating the chamber set.
Separate the chamber set from the product body.
Turn the hopper open and pull off the parts in
order to disassemble them.
Wash the parts with a cleaning brush under
running water.
Wash the chamber by opening the discharge cover
and the juice cap.
Wipe the product body with a damp towel or soft
cloth.
For silicon packings, remove and wash them after
use.
- Residue may remain stuck
(hopper packing, juice cap packing, extraction
packing, seal packing, screw packing).
You can sterilize the parts by soaking them in
warm water diluted with baking soda, citric acid or
vinegar.
※ Failure to clean the product immediately after use can
cause its stainless steel parts and other parts to corrode or
become discolored due to salt and pulp from the ingredients.
Contaminants may dry out and get stuck inside, making it
difficult to disassemble or clean it, as well as adversely affect
its performance. Be sure to clean and air dry it completely
after use and store it in a clean place. For long-term storage,
clean it with the cleaning brush first. Do not clean it with
boiling water or subject it to high temperatures. Do not use
abrasive cleaning products or tools like kitchen sink cleaners
or a stainless-steel sponge. Do not put it in a dishwasher or
dish dryer.
※
01
02
03
04
05
06
9. How to Disassemble and Clean
To Next Page
Loading...
Need help?
General
