07
Press [Rev] button on the operating
switchfor about 3~5 seconds and
stop it. Repeat this 2~3times.
[Rev] is the button to push back
the ingredients upward. [Rev] only
works while pressing the button, and
the rotation of the squeezing screw
stops If you release the button.
Press [On] button to operate after
reverse operation is completely
stopped.
When using [ON] or [Rev] button,
make sure that the squeezing screw
stops completely.
NOTICE
Even after following the directions above
and still doesn’t work, please unplug the
power cord and disassemble chamber
set, and clean it. And try it again. If the
rotation stops completely, you may
press the button to any direction you
want. (Same as when pressing [on]
during reverse operation)
6. When the squeezing screw
stops during the operation
7. Disassembling and Washing
Silicon Components
01
02
Open the juice cap, hold the chamber
and juice cap with one hand, and remove
the juice cap packing with your other
hand to disassemble. Please be careful
not to drop or damage the juice cap and
chamber when disassembling the unit.
Grab the chamber packing in the
chamber shaft with both hands, and
lift up to remove. Identify the upper and
lower part of the chamber packing and
assemble. (Refer to image)
It is the pulp stopper made of silicone at
the bottom of the chamber. Make sure
to close the extraction seal always as
shown below before use. For cleaning,
open the extraction seal and start
washing.
Juice Cap Packing
Chamber Packing
Extraction Seal
<ON>
<REV>
01
02
4DC010791 사용설명서(통합) HP 브러쉬(영어, 불어, 독어, 이태리어, 스페인어)_V.01.indd 7 2019-10-15 오후 5:26:23
To Next Page
Loading...
Need help?
General
