HUROM HP Series Instruction Manual

09
If you need additional information, please contact your local Customer Service Center or
visit www.globalhurom.com / www.hurom.com. When applying for after-sales service,
please have the manufacturer’s serial number or bar code available.
9. Please check the details below before contacting Technical Support
for repair.
01
02
03
04
05
06
07
08
09
10
The main body itself
will not work.
Please assemble
according to the
safetysensor.
The Appliance does
not work.
The appliance stops
during normal
peration.
There are fine lines or
scratch marks around
the squeezing screw.
Do not insert too many
ingredients at once.
Do not use in ways
other than pressing on
the pusher in the inlet.
Juice leaks over the
body.
The hopper does not
open.
The Chamber shakes
when squeezing.
For your safety, this unit only works when it’s correctly assembled
with the chamber set.
For your safety, this unit only works when it's correctly assembled.
Make sure that the power cord is properly plugged in.
Check if the hopper is assembled properly. If the hopper has not been
locked into place, the appliance will not operate for safety reasons.
Check if the appliance is assembled according to the direcons in the
manual. Refer to instrucons for assembly in the manual or consult
with your Customer Service Center for addional assistance.
Have you in heavy loads or large pieces of ingredients into the ap-
pliance?
Refer to page 07 of the manual and follow the guideline for using
[REV] buon. If the issue is not resolved aer following the above
process, please contact your local Customer Service Center.
These are molding marks resulng from the normal manufacturing
process.
This is a normal product and there is no problem for use.
If you insert an excessive amount of ingredients or thick ingredients,
the unit may stop.
It may cause damage, injury, etc.
Have you inserted a lot of ingredients into the hopper chute?
If you insert a large amount of ingredients compared to the pulp out-
let, the packing is slightly pushed away, so the juice leaks out of the
gap. Do not put too much ingredients by force and just put gradually
for extracon.
There might be a lot of residues inside.
Press [ON] buon to release residues. Press [REV] buon for 3~5 sec-
onds and stop it. Repeat this process 2~3mes.
Have you placed any foreign substances or solid objects (hard seed
such as persimmon seed) in the juicer?
Press [REV] buon and push the ingredients back up toward the hop-
per chute.Do not aempt to open by force. Please contact your local
Customer Service Center for assistance.
Slight shaking may be caused by the motor.
Depending on the texture of the ingredient, there may be slight to
more pronounced shaking of. This is a normal phenomenon as auger
rotates and it is not a malfuncon. Hard ingredients (e.g carrot, pota-
to, radish, beet, etc.) may cause more shaking than so ingredients.
4DC010791 사용설명서(통합) HP 브러쉬(영어, 불어, 독어, 이태리어, 스페인어)_V.01.indd 9 2019-10-15 오후 5:26:24

HUROM HP Series Specifications

General

Brand	HUROM
Model	HP Series
Category	Juicer
Language	English