To Next PageTo Next Page
Need help?Do you have a question about the HURST RABBIT TOOL and is the answer not in the manual?
The Rabbit Tool is pretested and ready for use. It is recommended to cycle the system a few times.
Record the serial number onto the warranty card and mail it to Hale Products, Inc. to begin warranty.
Observe all warnings, wear protective clothing, ensure connections are tight, and avoid hose damage.
Do not exceed PSI ratings, tamper with relief valves, or overfill the reservoir.
User must be familiar with operation, inspect cylinders, and avoid exceeding load limits.
Insert jaws between door and jamb, use pry bar if needed. Activate tool by turning pump relief valve.
Clean unit after exposure to water/dirt. Store vertically. Sequence and check system if stored long term.
Drain and refill with specified fluid every 300 hours. Ensure tool is fully retracted when adding fluid.
Addresses issues like erratic action, cylinder not opening, partial extension, or slow advancement.
Covers problems such as pump not delivering, losing pressure, not reaching full pressure, or spongy action.
Procedure to remove air from the hydraulic system after connections are made.
General
