What to do if hoses cannot be coupled on my HURST Streamline SP 777?
If the hoses cannot be coupled on your HURST Spreader, it could be due to pressure being too high, possibly from high ambient temperature. Try setting the hydraulic pump to pressureless circulation. Alternatively, the coupling might be defective and need immediate replacement.
Why is it frequently not possible to couple hose assemblies on my HURST Streamline SP 777?
If you frequently cannot couple hose assemblies on your HURST Spreader, this issue may arise if the hydraulic fluid isn't suited for the application or if the coupling is defective. In the first case the hydraulic fluid must be replaced. In the second case the coupling needs to be replaced immediately.
Why doesn’t my HURST Spreader perform at its given power?
If the HURST Spreader device isn’t performing at its given power, it may be due to insufficient hydraulic fluid in the pump. To resolve this, top up the hydraulic fluid and deaerate the system.
What to do if there is a leak in the couplings of my HURST Spreader?
If you notice a leak in the couplings of your HURST Spreader, it is probably because the coupling is damaged. The coupling must be replaced immediately.
What to do if there is a leak on the handhold of my HURST Streamline SP 777?
If you observe a leak on the handhold of your HURST Spreader, there could be several reasons: 1. A load increase (e.g. something has fallen onto the part to be lifted, thereby suddenly increasing the load): Secure the loads and move them by using other tools. 2. Pressure release in the Rescue tool: Following the reduction in pressure, no further leak is present. 3. Hoses in handhold not tightened: Tighten hoses. 4. Supply and return connection of the mono-coupling (female) inverted: Reconnect the hoses of the mono-coupling (female) in the right way.
To Next Page
General
