Why doesn’t my HURST SP 333 perform at its given power?
If the HURST Spreader device isn’t performing at its given power, it may be due to insufficient hydraulic fluid in the pump. To resolve this, top up the hydraulic fluid and deaerate the system.
Why hoses cannot be coupled to HURST Spreader?
Hoses might not couple to the HURST Spreader due to pressure being too high, possibly from high ambient temperature. Try setting the hydraulic pump to pressureless circulation. Alternatively, the coupling may be defective and needs immediate replacement.
What to do if there is a leak in the couplings of HURST SP 333 Spreader?
If you discover a leak in the couplings of your HURST Spreader, the coupling is likely damaged and must be replaced immediately.
Why is it frequently not possible to couple hose assemblies of HURST SP 333?
If you frequently struggle to couple hose assemblies to your HURST Spreader, it could be due to hydraulic fluid not adapted to the application. In this case, the hydraulic fluid must be replaced. Another possible reason is a defective coupling, which needs to be replaced immediately.
Why doesn’t HURST Spreader perform at its given power?
If your HURST Spreader isn’t performing at its specified power, the cause might be insufficient hydraulic fluid in the pump. To resolve this, top up the hydraulic fluid and deaerate the system.
What to do if there is a leak on the handhold of HURST Spreader?
If you observe a leak on the handhold of your HURST Spreader, it could be caused by the hose connection to the couplings being interchanged. Reconnect the hoses to the coupling in the correct way. Alternatively, the return line may be disabled. Disconnect the return line from the coupling, clean it, and then reconnect it.
What to do if the star grip doesn’t return to the central position on my HURST Spreader?
If, following release, the star grip doesn’t return to the central position on your HURST Spreader, it indicates damage to the torsion spring for reset. For this, repair by an authorised dealer, by personnel specially trained by HURST, or by HURST itself is needed.
What to do if there is a leak in the couplings of my HURST SP 333 Spreader?
If you notice a leak in the couplings of your HURST Spreader, it is probably because the coupling is damaged. The coupling must be replaced immediately.
Why is it frequently not possible to couple hose assemblies on my HURST SP 333?
If you frequently cannot couple hose assemblies on your HURST Spreader, this issue may arise if the hydraulic fluid isn't suited for the application or if the coupling is defective. In the first case the hydraulic fluid must be replaced. In the second case the coupling needs to be replaced immediately.
What to do if there are damages on the hydraulic hoses of my HURST Spreader?
If you observe damages on the surface of the hydraulic hoses of your HURST Spreader, this is likely due to mechanical damages or contact with aggressive agents. The solution is to replace the hoses.
To Next Page
General
