To Next PageTo Next PageWhat to do if my Husky Irrigation System timer does not water?
If your Husky Irrigation System timer isn't watering or turning on at the set time, ensure the faucet is on, the clock is set to the correct time (including AM/PM), the batteries aren't low, the desired outlet (left or right) is programmed, rain delay is off, and the start time is correctly set, including AM/PM.
Why is my Hubspace device not connecting to Wi-Fi?
Your Hubspace device may not be connecting to Wi-Fi because your internet connection or Wi-Fi network is down. Ensure that your device is connected to a power source.
What to do if water won’t turn off on my Husky 1010 461 413?
If the water won’t turn off on your Husky Irrigation System, make sure the watering duration is set to the desired time and the manual mode is off.
What to do if my Husky device is offline for long periods of time?
Ensure your Wi-Fi signal strength is sufficient. You may need to move your router, use mesh Wi-Fi, or Wi-Fi extenders.
What to do if I scanned the QR code, but the app cannot connect to it?
Turn off Bluetooth on your phone and turn it back on. Then, scan the QR code. If the problem persists, turn your phone off and on, then try again.
What to do if I have low water pressure on my Husky 1010 461 413 Irrigation System?
If you're experiencing low water pressure with your Husky Irrigation System, ensure the faucet is completely open and use only one port at a time.
General| Brand | Husky |
|---|---|
| Model | 1010 461 413 |
| Category | Irrigation System |
| Language | English |
Retailer warrants product against defects in workmanship/materials within original purchaser's limited time.
Product is guaranteed free of defects in materials and workmanship for 1 year from date of purchase.
Instructions for removing battery tray, inserting two AA batteries, and replacing the tray securely.
Guide on attaching the timer to an outdoor faucet and turning it on after programming.
Download Hubspace app, create an account, and follow on-screen instructions for setup.
Scan timer's QR code using the app to add it and perform an automatic direction check.
Connect the smart plug to power and follow app instructions to complete its setup.
Scan plug's QR code using the app to add it to your account.
Configure the smart plug to act as a Wi-Fi gateway for remote control of the timer.
Connect the smart plug to Google Home or Alexa for voice-controlled watering.
Addresses issues like timer not watering, water not turning off, or low water pressure.
Covers connectivity, QR code issues, offline status, and multiple product scanning problems.
