To Next PageTo Next Page
Need help?Do you have a question about the Husky DPFR2190 and is the answer not in the manual?
General| Operating Pressure | 70-120 PSI |
|---|---|
| Air Inlet | 1/4 in. NPT |
| Type | Framing Nailer |
| Power Source | Pneumatic |
| Fastener Length | 2 in. - 3-1/2 in. |
Details the limited warranty period and coverage for the tool.
Explains signal words like WARNING and CAUTION for risk assessment.
Warns about chemicals in the product linked to cancer or birth defects.
Provides recommendations for maintaining a safe operating environment.
Crucial safety measures for the user during operation.
Information and requirements for servicing and repairing the tool.
Specifies necessary air pressure and quality for the tool's operation.
Outlines fundamental rules for safe and effective tool operation.
Details safe practices for connecting air supply and hoses.
Step-by-step procedure for loading fasteners into the tool.
Instructions for safely removing fasteners from the tool.
Procedures for removing a jammed fastener from the tool.
Explains the purpose and use of the non-marring pad.
Guidance on adjusting air pressure to achieve desired fastener depth.
How to use the depth adjustment wheel for precise settings.
Explanation of sequential and contact actuation modes.
Information regarding the tool's anti-dust cap.
How to properly lubricate the tool for optimal performance.
Safe and effective methods for cleaning the tool.
Recommendations for using the tool in cold weather.
Diagram and advice for air compressor connections and setup.
