• You can use the same method to adjust
'seconds' if you wish.
• Press E to update the FS3 clock and
return to the Utility menu.
• Press J to select the Set Date option and
press E.
• Set the date by using I and J to select
each parameter, and G and H to adjust its
value, as you did for the time.
• Press E to update the FS3 calendar and
return to the FS3 Utility menu.
6. Set up the rechargeable battery type:
Note: If non-rechargeable alkaline batteries are
fitted, skip step 6 by pressing C to return to the
DOS prompt.
• Press J until Non-volatile
Configuration is selected. Press E.
• Press J until SPM Battery type is
selected. Press G or H to select either
Nicad or NiMH rechargeable battery type.
Press E, and press E again.
• The FS3 will reset. Follow the instructions in
step 4 above, but then continue at step 7.
7. Set up the Power Management mode: to
Standard (SPM), Advanced (APM), or Fast (FPM).
• Hold down the L (BACKLIGHT/PAW) key and
press
H
. This will display an information
screen which includes a menu of options.
• Use J to select Power, and press E.
• The FS3 is normally supplied with SPM
selected (standard power management). If
this is acceptable, confirm that SPM is
displayed, and skip to step 8 below.
• If you wish to change the charging mode,
press G to select APM (or H for FPM). Press
E to go to the Power Parameters menu.
• Use H to adjust Power remaining to 0%
(skip this step if you selected FPM).
• Use J to select the Battery chargeable
option, then press H to select Yes.
Note: If non-rechargeable alkaline batteries
are fitted, you must select No.
To Next Page
Loading...