• Press J to select Battery capacity. Use
G or H to adjust the value to 1600 mAh for a
NiCd battery, or 2100 mAh for a NiMH battery.
• • Use J to select Charging Authorisation,
and H to select Level 4 in APM (or Level 3
in FPM).
Note: If non-rechargeable alkaline batteries
are fitted, you must select Level 1.
8. Accept the settings by pressing E.
Press C to return to the DOS prompt.
9. Charge the battery: press P to turn off the FS3
and leave it connected to the FS3 AC Adaptor or
Rack to charge for at least 8 hours (APM or FPM)
or overnight (SPM).
Note: If non-rechargeable alkaline batteries are
fitted, you must skip step 9.
The FS3 is now ready for use.
Note: After an application has been loaded into FS3,
access to SETTING UP functions may be different.
Refer to instructions provided with your application.
CONTROLS
Note: Your application's user instructions may
supplement the following information.
Turning on and off
Press P to turn on, or off. To conserve power, the
FS3 turns off automatically if you have not pressed
any keys for a short while.
Screen contrast
Adjust the screen contrast for optimum readability,
especially at temperature extremes. Hold down
either S (SHIFT) key and press G to increase
contrast or H to decrease contrast.
Screen backlight
In low ambient light, press L to turn the backlight
on. To turn it off, press L again. You may need to
press
LL
at the same time (depending how your FS3
is set up). The backlight turns off automatically after
a short time, to conserve power.
To Next Page
Loading...