Alternatively, if your system includes the HUSKY FS
Communications & Charging Rack, you can
recharge a unit by placing it on the Rack.
Replacing the battery
• Turn off the FS3.
• Remove the battery cap by using a suitable coin.
• Do not allow rain or moisture into the battery
compartment.
• Tilt the unit to slide out the battery pack.
• Slide the replacement HUSKY FS3 battery pack
into the battery compartment, positive end first.
• Refit the battery cap. Seat it with finger pressure
first and make sure that it has engaged the screw
threads before tightening it with a suitable coin.
• Turn on the FS3 and check operation.
• If you can't turn on, you may need to reset the
FS3 as described in the CONTROLS section.
• After changing the battery, you MUST ensure
that the battery type, capacity and power
management are correctly set. (Refer to your
application's user instructions.)
CAUTION: Alkaline batteries are not generally
recommended for use with the FS3 and should only
be fitted in an emergency, as a temporary measure, or
for light duty applications. If you fit them, warn
anyone you give the unit to – non-rechargeable
batteries must NOT be recharged.
Always use batteries of the same type and charge
state – don't mix fresh batteries with used batteries,
or rechargeable batteries with non-rechargeable ones.
Observe the instructions printed on the battery.
Replace only with batteries approved by your FS3
supplier. DO NOT FIT LITHIUM BATTERIES.
ATTENTION: Dispose of or recycle used batteries
according to the manufacturer's instructions, or local
waste management regulations. Nickel-Cadmium
rechargeable batteries must be recycled, or disposed
of properly. Do not dispose of batteries in fire.
CAUTION: BATTERY CHEMICAL LEAKAGE IS
CORROSIVE. In the unlikely event of battery leakage,
do not touch. In case of accidental contact, flush
immediately with running water.
To Next Page
Loading...