Husqvarna 125BV x-series User Manual (English)

Questions and Answers:

R
Renee WeeksJul 27, 2025
How to fix a Husqvarna 125BV x Blower that will not start?
- A
  Andrea PerezJul 27, 2025
  If your Husqvarna Blower engine won't start, several factors could be the cause. It could be due to an engine flood, in which case you should refer to the “Starting a Warm Engine” section. Other potential reasons include an empty fuel tank (fill it with the correct fuel mixture), a faulty spark plug (install a new one), or fuel not reaching the carburetor (check for a dirty fuel filter and replace it, or inspect the fuel line for kinks or splits and repair or replace it). If compression is low, contact an authorized service dealer.
D
davidhamiltonAug 3, 2025
What to do if Husqvarna 125BV x Blower engine lacks power?
- L
  Lisa HerreraAug 3, 2025
  If your Husqvarna Blower engine won't accelerate, lacks power, or dies under a load, consider these potential causes: a dirty air filter (clean or replace it), fuel not reaching the carburetor (check for a dirty fuel filter and replace it, or check for a kinked or split fuel line and repair or replace it), or a fouled spark plug (clean or replace the spark plug and re-gap it). For carburetor adjustments, carbon build-up, or low compression, contact an authorized service dealer.
A
amber94Aug 10, 2025
Why does my Husqvarna Blower smoke so much?
- A
  Alicia TerryAug 10, 2025
  Excessive smoke from your Husqvarna Blower engine can be attributed to several factors. The choke might be partially on, so adjust it. The fuel mixture could be incorrect; in that case, empty the fuel tank and refill it with the correct fuel mixture. Also, a dirty air filter might be the cause, so clean or replace it. If the carburetor requires adjustment, contact an authorized service dealer.
W
William HarveyAug 18, 2025
What causes a Husqvarna 125BV x Blower to run hot?
- F
  Frederick DouglasAug 18, 2025
  If your Husqvarna Blower engine runs hot, it could be due to an incorrect fuel mixture; see “Fuel mixture” in the FUEL HANDLING section. Another cause might be an incorrect spark plug, so replace it with the correct one. For carburetor adjustments or carbon build-up, contact an authorized service dealer.