Husqvarna 150BT - User Manual

Questions and Answers

D
David VasquezJul 25, 2025
How to fix a Husqvarna Blower when the engine is not possible to start?
- J
  Janet BrownJul 26, 2025
  If your Husqvarna Blower engine won't start, it could be due to several reasons. First, ensure the fuel type is correct by draining the tank and refilling it with the appropriate fuel. Also, check the spark plug to ensure it is dry, clean, and properly tightened. If the electrode gap is incorrect, clean the spark plug and adjust the electrode gap according to the technical data. Additionally, inspect the air filter and make sure it is clean. Blocked or worn starter pawls could also be the culprit; try cleaning around the starter pawls, adjusting or replacing the starter pawls, or consult an approved servicing dealer.
G
Gregory GreeneAug 2, 2025
How to troubleshoot a Husqvarna 150BT Blower that won't start?
- J
  Joshua RileyAug 2, 2025
  If your Husqvarna Blower's engine won't start, first ensure the spark plug is dry and clean. Also, check for correct electrode gap and tighten the spark plug if it's loose. Incorrect fuel mixture or a dirty air filter can also prevent starting, so ensure the fuel mixture is correct and the air filter is clean. Additionally, blocked or worn starter pawls can cause this issue; adjust or replace them and clean around them. Finally, make sure you're using the correct fuel type and adjust the idle speed with the idle adjustment screw.
W
wesley35Aug 9, 2025
What to do if Husqvarna 150BT engine starts but stops again?
- J
  Justin StephensAug 9, 2025
  If your Husqvarna Blower engine starts and then stops, the issue might be due to incorrect fuel. Drain the fuel tank and refill it with the correct fuel. Another potential cause is a clogged air filter, so try cleaning the air filter. If the engine still won't operate correctly at idle speed, it's best to speak to your servicing dealer.
K
Kimberly AndersonAug 17, 2025
What to do if my Husqvarna Blower engine starts but stops again?
- M
  mcdonaldbonnieAug 17, 2025
  If your Husqvarna Blower starts but then stops, the issue might be with the fuel, air filter, or idle speed. Make sure you're using the correct fuel by draining the fuel tank and refilling it with the correct fuel. A clogged air filter could also be the problem, so try cleaning it. If the engine won't operate correctly at idle speed, it is best to speak to your servicing dealer.

Summary

EC Declaration of Conformity

EC Declaration of Conformity [130 BT]

Declaration for Husqvarna 130BT model per EU directives.

EC Declaration of Conformity [150 BT]

Declaration for Husqvarna 150BT model per EU directives.

EC Declaration of Conformity [170 BT]

Declaration for Husqvarna 170BT model per EU directives.

EC Declaration of Conformity [180 BT]

Declaration for Husqvarna 180BT model per EU directives.

Safety Information

Safety First and Warnings

Critical instructions to prevent serious injury and explanation of warning types.

General Safety Precautions

Fuel Handling Safety

Critical safety warnings and procedures for handling fuel.

Pre-Operation Checks

Safe Product Usage

Assembly and Setup

Swivel Joint and Throttle Assembly

Harness and Waist Belt Fitting

Fueling and Fuel Management

Fueling Procedures and Safety

Safe practices for refueling the blower and its fuel tank.

Fuel Mixing and Engine Care

Correct fuel mix ratios and advice for engine longevity.

Operating the Blower

Engine Starting Procedure

Step-by-step instructions for starting the engine.

Engine Stopping Procedure

Maintenance and Care

Maintenance Schedule and Air Filter Care

Husqvarna 150BT Specifications

General

Engine Displacement	50.2 cc
Fuel Tank Volume	42.27 fl oz
Engine Type	2-stroke
Sound Power Level	104 dB(A)
Maximum Air Volume	434.37 cfm
Dry Weight	4.7 kg
Maximum Air Speed	75 m/s