Maintenance Daily maintenance
before operation
Maintenance interval
in hours
25 50 100 200
Examine the muffler and heat deflector O
Examine the cutting deck for damages O
Change the spark plug O
Adjust the parking brake. O
Do a check of and adjust the throttle wire O
Clean the cooling fins on the engine and the transmission O
Clean the engine and the transmission O
Do a check of/adjust front and rear wheel speed O O
Do a check of the belts O O
Do a check of the battery O
Do a check of the fuel hose. Replace it if necessary O
Change the oil in the transmission O O
Change filter in the transmission O O
Change the spin-on filter of the servo O O
To clean the product
CAUTION: Do not use a high pressure
washer or a steam cleaner. Water can go
into bearings and electrical connections and
cause corrosion which cause damage to the
product.
Clean the product directly after use.
• Do not clean hot surfaces such as the engine,
muffler and exhaust system. Wait until the surfaces
are cool, then remove the grass or dirt.
• Before you clean with water, clean with a brush.
Remove grass cuttings and dirt from on and around
the transmission, the transmission air intake, and the
engine.
• Use running water from a hose to clean the product.
Do not use a high pressure.
• Do not point the water at electrical components or
bearings. Detergent usually increases the damage.
• To clean the cutting deck, put it in the servicing
position and hose it down with water.
• When the product is clean, start the cutting deck for
a short period to blow off remaining water.
To clean the engine and the muffler
Keep the engine and muffler free from grass cuttings
and dirt. Grass cuttings soaked in fuel or oil on the
engine can increase the fire risk and the risk that the
engine becomes too hot. Let the engine cool before it is
cleaned. Clean with water and a brush.
Grass cuttings around the muffler dry quickly and are a
fire risk. Use a brush or remove the grass cuttings with
water when the muffler is cold.
To clean the cold air intake of the
engine
WARNING: Stop the engine. The cold air
intake rotates and can cause injury to your
fingers.
270 - 001 - 28.11.2017 19
To Next Page
Loading...
