CONTENTS
Husqvarna AB has a policy of continuous product development
and therefore reserves the right to modify the design and
appearance of products without prior notice.
Maintenance, replacement, or repair of the emission control
devices and systems may be performed by any nonroad
engine repair establishment or individual.
S IMPORTANTENGINEINFORMATION
HUSQVARNAAB HUSI(VARRASWEDEN _
THISENGINECONFORMSTO U.S. EPA PH2
EMISSIONREGULATIONSFORSMALLNONROADENGINES.
REFERTO OPERATOR'SMANUALFOR
MAINTENANCESPECIFICATIONSANDADJUS'IMENTS.
\ EMISSIONSCOMPLIANCEPERIOD:CA'IEGORY_ /
The Emissions Compliance Period referred to on the
Emissions Compliance label indicates the rmmber of operating
hours for which the engine has been shown to meet Federal
emission requirements.
Category C = 50 hours, B = 125 hours, and A = 300 hours.
WARNING
The engine exhaust from this product
contains chemicals known to the State
of California to cause cancer, birth
defects or other reproductive harm.
I For customer assistance call: 704-921-7000 or
I
contact us at our website: www.husqvarna.com I
I
List of contents
SYMBOL EXPLANATION
Symbols ............................................................................... 2
CONTENTS
List of contents .................................................................... 3
SAFETY INSTRUCTIONS
Personal protective equipment ............................................. 4
The machine's safety equipment .......................................... 4
Control, maintermnce and service of the machine's safety
equipment ...................................................................... 6
Cutting equipment .............................................................. 7
General safety instructions ................................................... 8
General working instructions ............................................... 9
Basic working techniques ..................................................... 9
WHAT IS WHAT?
What is what on the trimmer? ............................................ 11
ASSEMBLY
Assembling the loop handlebar (325C, 325Cx) .................. 12
Assembling the loop handlebar
(322L, 323L, 325L x, 325Lxv 325LDx) .......................... 12
Assembling and dismantling the two-part shaft
(325Lv_, 325LDx) ......................................................... 12
Assembly of the trimmer head ........................................... 12
Assembling the spray guard and trimmer head
Superauto II (322L, 323L, 325L x, 325Lx_, 325LDx) ..... 13
Assembling other guards and cutting equipment
(322L, 323L, 325L x, 325Lv_, 325LDx) .......................... 13
Fitting the spray guard and trimmer head (325C) .............. 13
Fitting the spray guard and trimmer head (325Cx) ............ 14
FUEL HANDLING
Fuel mixture ...................................................................... 15
Fuelling .............................................................................. 15
START AND STOP
Control before starting ....................................................... 16
Start and stop ..................................................................... 16
MAINTENANCE
Carburetor ......................................................................... 17
Muffler .............................................................................. 19
Cooling system .................................................................. 19
Spark plug .......................................................................... 19
Two-part shaft .................................................................... 19
Air filter ............................................................................. 20
Angle gear .......................................................................... 20
Maintenance schedule ........................................................ 20
TECHNICAL DATA
322L/323L ........................................................................ 21
325L x ................................................................................ 21
325Lx, I................................................................................ 21
325LD x.............................................................................. 21
325C ................................................................................. 22
325C x ................................................................................ 22
EMISSION CONTROL WARRANTY STATEMENT
Your warranty rights and obligations .................................. 23
English - 3