4 Starter
Apply a light coating of oil to starter pulley post
and recoil spring.
Position starter pulley on starter housing as
shown. Rotate pulley to engage recoil spring in
pulley.
IMPORTANT:
Starter pulley must be flush
against recoil spring.
Secure starter pulley with washer and screw.
Install guard ring with screws. Pull starter han-
dle out and stop starter pulley with thumb. Lift
cord into pulley recess, then preload spring by
turning pulley three turns clockwise.
14
For Husqvarna Parts Call 606-678-9623 or 606-561-4983
www.mymowerparts.com
To Next Page
Loading...
