Need help?Do you have a question about the Husqvarna 40 and is the answer not in the manual?
General| Chain Pitch | 3/8" |
|---|---|
| Weight | 4.4 kg |
| Oil Tank Volume | 0.2 liters |
| Chain Gauge | 0.050 inches |
| Bar Length | 13-18 in (33-45 cm) |
Details the fuel and oil supply systems.
Procedures for testing crankcase and cylinder vacuum integrity.
Process for pressure testing the carburettor.
Steps for chain brake removal and function tests.
Servicing the throttle trigger and lockout mechanism.
Guidance on checking and replacing the chain catcher.
Procedure for spark check and ignition module adjustment.
Guidance on checking clutch shoe wear and replacement procedure.
A chart to diagnose lubrication and leakage issues.
Steps to unhook throttle cable and remove the carburettor.
Detailed guide for adjusting the carburettor settings.
Fine-tuning of low, high, and idle speed needles.
Disassembly of cylinder and crankshaft components.
How to change the crankshaft seal rings during engine rebuild.
Steps for assembling the piston and connecting rod.
Procedure for re-torquing cylinder screws after initial run-in.
To Next Page
