What to do if my Husqvarna 445 II starts then stops?
If your Husqvarna Chainsaw engine starts but stops again, the fuel type might be incorrect. Drain the fuel tank and refill it with the correct fuel. Also, a clogged air filter can cause this issue, so clean or replace the air filter. Another potential cause is a clogged fuel filter, which requires replacement.
What to do if Husqvarna Chainsaw fuel tank is filled with chain oil and the engine does not start?
If the Husqvarna Chainsaw engine does not start and the fuel tank is filled with chain oil, drain the fuel tank if you have not tried to start the product. If you have already attempted to start it, it is recommended to speak to your servicing dealer.
What to do if Husqvarna Chainsaw engine is flooded and does not start?
If the Husqvarna Chainsaw engine does not start, and you think it is flooded due to repeated starts with full choke after ignition, remove and clean the spark plug. Put the product on its side with the spark plug hole away from you. Pull the starter rope handle 6-8 times. Assemble the spark plug and start the product.
General| Engine Power | 2.1 kW |
|---|---|
| Cylinder Displacement | 45.7 cm³ |
| Weight (excl. cutting equipment) | 4.9 kg |
| Fuel Tank Volume | 0.45 L |
| Oil Tank Volume | 0.26 L |
| Sound Power Level | 114 dB(A) |
| Vibration Level (left/right handle) | 3.1/4.9 m/s² |
| Chain Pitch | 0.325 inch |
| Chain Gauge | 1.3 mm (0.05 in) |
The Husqvarna 445 II, 445e II, 450 II, 450e II are chainsaw models with a combustion engine.
Lists and describes the components of the chainsaw, referring to Fig. 1.
Explains various symbols used on the product and in the manual, with reference to figures.
Explains the meaning of warnings, cautions, notes, and provides general safety guidelines.
Details operational safety, Euro V emissions, and general warnings for safe use.
Lists and describes the essential protective gear required for safe chainsaw operation.
Safety aspects related to vibration damping, start/stop switch, muffler, and fuel.
Guidelines for performing maintenance tasks safely and correctly.
Step-by-step instructions for attaching the guide bar and saw chain to the chainsaw.
Introduction to operation, safety warning, and function check before using the product.
Information on correct fuel mixing, filling the fuel tank, and using chain oil.
Detailed steps for starting and stopping the chainsaw engine safely.
Information on kickback prevention and various cutting techniques for efficient use.
Guidance on calculating felling direction, preparation, and safe tree felling.
A table outlining daily, weekly, and monthly maintenance tasks for the chainsaw.
Detailed checks for all safety features to ensure proper function and prevent accidents.
Procedures for cleaning the air filter and checking/maintaining the spark plug.
Guidelines for sharpening the saw chain and adjusting its tension for performance.
Inspecting the guide bar for wear, blockages, and checking saw chain lubrication.
Procedures for draining and cleaning the fuel and chain oil tanks to prevent contamination.
Identifies common causes and actions for engine starting failures.
Addresses issues where the engine starts but then stops unexpectedly.
Safety guidelines for transporting and storing the product and fuel.
Steps for preparing the chainsaw for extended periods of storage.
Lists approved guide bar and saw chain combinations for safety and performance.
Recommended tools and angles for sharpening the saw chain cutters.
To Next Page