Ignition
System
5
Remove flywheel nut and washer (1).
starter pawls (2).
Remove
Remove piston stop P/N 5025033-01. Install
flywheel removal tool P/N 5025149-01 to the
flywheel with the M5 screws. Ensure puller
P/N 5025026-01 is centered, then tighten
puller screw and lightly tap puller, and remove
flywheel.
On G series saws (models with heated han-
dles) the generator is now visible and can be
removed. The sealing ring holder is located
behind the generator.
1
21
For Husqvarna Parts Call 606-678-9623 or 606-561-4983
www.mymowerparts.com
To Next Page
Loading...
