10
Fuel System
Assemble screws and washers (1), filter holder
(2), carburetor (3), gasket (4), manifold (5),
gasket (6) and screwdriver guide (7).
Installation of Carburetor
Connect throttle linkage to carburetor. Position
carburetor as shown and tighten screws (1). Be
sure fuel hose (2) is at least 95 mm (3-3/4 in.)
above fuel tank and connect choke linkage (3)
and, as equipped, heat switch lead (4). Install
air filter and cylinder cover.
42
For Husqvarna Parts Call 606-678-9623 or 606-561-4983
www.mymowerparts.com
To Next Page
Loading...
