Cvlinder and Piston
Assembly
NOTE:
Replace all gaskets when reassem-
bling piston/cylinder.
Position piston on connecting rod with arrow on
piston top facing the exhaust side as shown.
Apply a few drops of oil to wrist pin, Push wrist
pin into place. Secure wrist pin with new cir-
clips. Openings in circlips should be at either
12 o’clock or 6 o’clock.
Install new cylinder base gasket.
Secure muffler and carburetor to cylinder after
replacing gaskets.
Apply oil to piston. Install piston ring with open-
ing at piston pin. Install piston ring compressor
P/N 5025070-01 on piston as shown.
I
45
For Husqvarna Parts Call 606-678-9623 or 606-561-4983
www.mymowerparts.com
To Next Page
Loading...
