Husqvarna 435 - Accessories

435 440
Weight
Weight, lb/kg 9.7/4.4 9.7/4.4
Saw chain/guide bar
Recommended bar lengths
2
, inch/cm 13-18/33-45 13-18/33-45
Pitch, inch/mm 0.325/8.25 0.325/8.25
Thickness of drive links, inch/mm 0.050/1.3 0.050/1.3
Type of drive sprocket/number of
teeth
Spur/7 Spur/7
Saw chain speed at 133% of maxi-
mum engine power speed, ft/s / m/s
75.5/23.1 75.5/23.1
Accessories
Recommended cutting equipment
A specific chainsaw model has to be evaluated with
the cutting equipment to be recommended and fulfill the
requirements in ANSI B175.1-2012 (Internal Combustion
Engine-Powered Hand-Held Chainsaws - Safety and
Environmental Requirements) and Canadian Standards
CSA Z62.1-15 (Chainsaws) and CSA Z62.3-11 (R2016)
(Chainsaw kickback).
Chainsaw models Husqvarna 435, 440 met the safety
requirements in ANSI B175.1-2012 and Canadian
Standards Association CSA Z62.1-15 (Chainsaws) and
CSA Z62.3-11 (R2016) (Chainsaw kickback), when
equipped with the below listed saw chain and guide bar
combination(s).
Note: Other chainsaw models may not meet the
kickback requirements when equipped with the listed
guide bar and saw chain combinations.
We recommend only to use the listed guide bar and saw
chain combinations.
Low kickback saw chain
A saw chain that is designated as Low kickback saw
chain, meets the low kickback requirement specified in
ANSI B175.1-2012.
Kickback and guide bar nose radius
For sprocket nose bars the nose radius is specified by
the number of teeth, such as 10T. For solid guide bars
the nose radius is specified by the dimension of the
nose radius. For a given guide bar length, you can use a
guide bar with smaller nose radius than given.
Guide bar Saw chain
Length, in Pitch, in Gauge, mm/in Max. nose ra-
dius
Type Low kickback Length, drive
links (no.)
13
0.325 1.3/0.050 10T
Husqvarna
SP33G
Husqvarna
H30
Yes
56
15 64
16 66
18 72
2
The nominal guide bar size is not necessarily the same as the cutting length.
34 1270 - 007 - 06.12.2022