10 Instruction book Lily 555/545
Threading the upper thread
Make sure the presser foot
is raised and the needle is
in the up position
1. Pull the spool pin out.
Place the thread on the
spool pin and the spool
holder on the spool pin
as described. Push the
spool pin back in.
2. Bring the thread in the
direction of the arrow
under the thread guide (a) and
over the thread guide (b).
3. Bring the thread down between
the thread tension discs.
4. Continue threading by drawing
the thread from the right into the
slot on the take-up lever.
5. Thread last guide just above
needle.
6. The needle is threaded from front
to back. The white on the press-
ser foot ankle makes it easy to
see the eye of the needle.
Procedures
7. Place thread under the presser
foot and into the thread knife
where it is cut.
To Next Page
Loading...
