9Instruction book Lily 555/545
d
c
Spool pin
The machine has spool pins suitable
for all types of thread. The main
spool pin (a) is horizontal - the
thread reels off the stationary spool.
Place the spool so that the thread
reels counter-clockwise.
There are two spool holders on
the spool pin. With narrow thread
spools, the small holder (b) is pla-
ced in front of the thread. If you use
large thread spools, the large holder
(c) is placed in front of the thread.
Slide the correct size spool holder
in place so the fl at side is pressed
fi rmly against the spool. No space
between spool holder and spool.
There is also a separate spool pin
(d) to be attached onto the machine.
The fi ngers on the extra spool pin fi t
into the two holes to the right of the
fi xed spool pin. Push downward to
snap in place.
The large spool holder (c) is placed
under the thread. This spool pin is
used when winding a bobbin from
a second spool of thread or for a
second spool when sewing with a
twin needle.
Procedures
a
b
c
d
To Next Page
Loading...
