16 Instruction book Lily 555/545
Changing the needle
1. Loosen the screw in the needle
clamp.
2. Remove the needle.
3. Push up the new needle with the
fl at side away from you until it
will go no further.
4. Tighten the screw properly.
Always use needles of system
130/705H.
Lowering the feed teeth
The feed teeth are lowered when
you turn the dial to the left to
. Turn the dial to the right to if
you wish to raise the feed teeth. The
feed teeth will not come up until
you begin to sew.
The feed teeth are lowered when
sewing buttons and for free-hand
work.
By lowering the feed teeth it is ea-
sier to get thick garments under the
presser foot. Do not forget to raise
the feed teeth before starting to sew.
Procedures
To Next Page
Loading...
