Need help?Do you have a question about the Husqvarna 6010 and is the answer not in the manual?
General| Brand | Husqvarna |
|---|---|
| Model | 6010 |
| Category | Sewing Machine |
| Language | English |
Details on adjusting the lower thread tension using the spring on the bobbin case.
Explanation of the upper thread tension control, including the discs, spring, and washer.
How the foot control adjusts speed via an electronic circuit and motor regulation.
Explanation of how the pattern mechanism controls needle position and feed direction.
How the buttonhole mechanism and radial curves determine stitch width for buttonholes.
Ensuring the foot control provides continuously controllable speed from slow to full.
Ensuring the machine maintains a lowest speed of 100 rev/min.
Ensuring correct distance between stitch plate and needle tip when stopped.
Steps to adjust the needle's upper stop-right position by moving the handwheel.
Ensuring side movement of the needle is completed before the tip of the needle reaches the stitch plate.
Adjusting handwheel and set screws to center the cam follower on the cam lobe.
Ensuring correct gap between needle and hook for thread loop formation.
Adjusting needle bar by turning handwheel, removing screws, and setting the driver position.
Adjusting upper thread tension by separating tension discs and aligning indicators.
Adjusting upper thread tension by checking needle parallelism and thread deflection.
Ensuring the thread tension spring provides 20-24 grams resistance when pulling thread.
Adjusting bobbin case tension by turning the programmer and checking thread pull.
To Next Page
