Need help?Do you have a question about the Husqvarna VIKING 600 and is the answer not in the manual?
General| Brand | Husqvarna |
|---|---|
| Model | VIKING 600 |
| Category | Sewing Machine |
| Language | English |
Adjusting the hook's position relative to the feeding eccentric for correct timing (one pin version).
Adjusting the hook's position relative to the feeding eccentric for correct timing (two pin version).
Setting the presser foot parallel to the stitch plate and its lifted height.
Symmetrically positioning the feed dog in relation to the presser foot for proper feeding.
Initial calibration of the needle step motor for accurate positioning.
Adjusting the minimal gap between the needle point and the hook tip.
Aligning the stitch plate so the needle enters the center of the needle hole.
Ensuring the stitch plate does not touch the feed dog at any point.
Checking and adjusting the distance between the bobbin case and the case holder.
Synchronizing the hook's movement with the needle's upward motion for correct stitch formation.
Setting the correct vertical position of the needle relative to the hook ring.
Adjusting the feed dog height to ensure proper fabric feeding.
Initial calibration of the feed dog step motor for accurate movement.
Setting the correct resistance for the bobbin thread tension spring.
Adjusting the main thread tension for proper take-up during stitching.
Troubleshooting steps when the machine fails to read the memory card.
Diagnosing and resolving issues where the embroidery unit only feeds in the specified direction.
Troubleshooting the upper thread break detection and machine stopping function.
Diagnosing and resolving issues with the embroidery unit sewing designs incorrectly.
To Next Page