Need help?Do you have a question about the Husqvarna CR 50 / 2011 and is the answer not in the manual?
General| Cooling | Liquid cooled |
|---|---|
| Transmission | 6-speed |
| Rear Suspension | Sachs monoshock |
| Front Tire | 60/100-14 |
| Rear Tire | 80/100-12 |
| Seat Height | 685 mm |
| Engine Type | Single cylinder, 2-stroke |
| Displacement | 49 cc |
| Starter | Kickstarter |
| Final Drive | Chain |
| Engine | Single cylinder, 2-stroke |
| Front Suspension | Telescopic fork |
| Front Brake | Single disc |
| Rear Brake | Single disc |
| Bore x Stroke | 39.5 x 40 mm |
Rules for operator and persons working nearby.
Consequences of non-compliance with instructions.
Recommendations for effective service work.
Key practices for workshop procedures.
Warranty for CR models and scheduled maintenance.
Client's role in maintaining vehicle warranty.
Definition of left and right side when seated.
Engine bore, stroke, displacement, carburettor type, jets.
Frame type, front/rear suspension travel, and types.
Rim size, tyre make, and cold tyre pressure.
Kerb weight, maximum width, and capacities.
Engine maintenance tasks and intervals.
Chassis maintenance tasks and intervals.
Routine checks before use and after cleaning.
Causes and remedies for engine start/stall problems.
Diagnosing engine noises, overheating, and low power.
Troubleshooting steering, vibration, and suspension.
Diagnosing braking problems and electrical system faults.
Adjusting carburettor settings and idle RPM.
Clutch setting, wear compensation, and replacement.
Adjusting front brake lever and rear brake pedal.
Adjusting spring preload and damping.
Adjusting steering head bearing play.
Steps to remove number holder, mudguards, saddle, side panels.
Removing rear chassis, airbox, exhaust system.
Detailed procedures for engine removal.
Original carburettor settings and adjustment info.
Proper cleaning and storage for long inactivity.
Procedures for disassembling engine components.
Procedures for reassembling engine parts.
Specifications for engine bore, stroke, and other data.
Steps to remove the front fork assembly.
Details on front fork spring length and constant.
Steps to remove the rear shock absorber.
Disassembly and servicing of the swinging arm.
Components of the front and rear braking systems.
Checking brake disc diameter, thickness, and warpage.
Procedures for removing and installing brake pads.
Schematic of the motorcycle's electrical system.
Inspecting spark plug, gap, and condition.
How to check and maintain coolant levels.
Illustration of the cooling system components and flow.
List of special tools with part numbers.
Torque values for chassis fasteners.
Torque specs for suspension components.
Torque values for wheels and brake fasteners.
Locations for chassis lubrication.
Steps to remove and install the front wheel.
Steps to remove the rear wheel assembly.
Bearing service, axle warpage, and runout checks.
Inspecting chain and sprockets for damage or wear.
To Next Page