21
V-BELTS
Check V-belts for deterioration and wear after 100 hours
of operation and replace if necessary. The belts are not
ad just able. Re place belts if they begin to slip from wear.
BATTERY
Your tractor has a battery charging system which is suf fi cient
for normal use. However, periodic charging of the battery
with an automotive charger will extend its life.
• Keep battery and terminals clean.
• Keep battery bolts tight.
• Keep small vent holes open.
• Recharge at 6-10 amperes for 1 hour.
NOTE: The original equipment battery on your tractor is main-
tenance free. Do not attempt to open or remove caps or cov-
ers. Adding or checking level of electrolyte is not necessary.
TO CLEAN BATTERY AND TERMINALS
Corrosion and dirt on the battery and terminals can cause
the battery to “leak” power.
• Remove battery cover.
• Disconnect BLACK battery cable first then RED bat-
tery cable and remove battery from tractor.
• Rinse the battery with plain water and dry.
• Clean terminals and battery cable ends with wire brush
until bright.
• Coat terminals with grease or petroleum jelly.
• Reinstall battery (See “REPLACING BATTERY" in the
SERVICE AND ADJUSTMENTS section of this man u al).
Fig. 28
6 STAR PATTERN BLADE (See Fig. 28)
The center of this blade has a 6 star pattern. The bolt at tach-
ing this blade has Left Hand threads that loosens by turning
( ) clockwise and tight en by turning ( ) coun ter clock wise.
BLADE REMOVAL
• Raise mower to highest position to allow access to
blades.
• Remove blade bolt, lock washer and flat washer se cur-
ing blade.
• Install new or resharpened blade with trail ing edge up
towards deck as shown.
IMPORTANT: To ensure proper as sem bly, center hole in
blade must align with star on mandrel assembly.
• Reassemble blade bolt, lock washer and flat washer
in exact order as shown.
• Tighten blade bolt securely (27-35 Ft. Lbs. torque).
IMPORTANT: BLADE BOLT IS GRADE 8 HEAT TREATED
TRANSAXLE MAINTENANCE
The transmission fan and cooling fins should be kept clean
to assure proper cooling.
Do not attempt to clean fan or transmission while engine
is running or while the transmission is hot. To prevent pos-
si ble damage to seals, do not use high pressure water or
steam to clean transmission.
• Inspect cooling fan to be sure fan blades are intact and
clean.
• Inspect cooling fins for dirt, grass clippings and other
materials. To prevent damage to seals, do not use
compressed air or high pressure sprayer to clean
cool ing fins.
TRANSAXLE PUMP FLUID
The transaxle was sealed at the factory and fluid main te-
nance is not required for the life of the transaxle. Should
the transaxle ever leak or require servicing, contact your
near est au tho rized ser vice center/department.
MAINTENANCE
Fig. 27
5 STAR PATTERN BLADE (See Fig. 27)
The center of this blade has a five (5) star pattern. The bolt
that attaches this blade has nor mal Right Hand threads
that loosens by turn ing (
) counterclockwise and tight ens
by turning ( ) clockwise.
BLADE BOLT
LEFT HAND
THREADED
LOCK
WASHER
FLAT
WASHER
BLADE
MANDREL
ASSEMBLY
6 STAR
PATTERN
6 STAR CENTER HOLE
TRAILING
EDGE
BLADE BOLT
RIGHT HAND
THREADED
LOCK
WASHER
FLAT
WASHER
BLADE
MANDREL
ASSEMBLY
5 STAR
PATTERN
5 STAR CENTER HOLE
TRAILING
EDGE
To Next Page
Loading...
