8
ASSEMBLY
02306
HOOK
BACKPLATE
SLOT
DISCHARGE
CHUTE
Fig. 6
Fig. 7
CLEVIS PIN 3/8 X 11/16
CLEVIS PIN 3/8 X 2
SUPPORT BRACKET
13/32 FLAT WASHER
RETAINER SPRING
0
28
1
3
SUPPORT BRACKET
Fig. 8
TO ASSEMBLE BAGGER (See Figs. 8-10)
• Unfold bag by pivoting front bagger tube all the way
forward and pressing the bottom vinyl binding onto the
tube.
• Inside the bag, install spreader bars and retainer springs
onto pins on both sides of bag as shown.
• Press the vinyl bindings onto the sides of front bagger
tube.
0290
5
FRONT BAGGER TUBE
VINYL
BINDING
Fig. 10
Fig. 9
0
2906
SPREADER BARS
(Inside of bag)
RE TAIN ER
SPRING
VINYL
BINDING
VINYL
BINDING
RE TAIN ER
SPRING
02907
CLEVIS PIN
3/8 X 1-3/4
RE TAIN ER
CLIP
DUMP HANDLE
TUBE
CAP
NOTE: For tractors with an electric dump system, refer to
the kit instructions for more assembly procedures.
MANUAL BAGGER DUMPING ONLY:
• Slide the bagger dump handle through the hole in the
bagger top, install the clevis pin 10 x 44mm and secure
with retainer clip.
• Push cap over end of bagger dump handle.
NOTE: For future use, the clevis pin may be removed in
order to use the handle to clear the chute in the event it
has become clogged.
To Next Page
Loading...
