Husqvarna EZ4824 - Fuel Filter

MAINTENANCE
42-Husqvarna
Fuel Filter
Replace the line-mounted fuel lter every 100 hours
(once per season) or more regularly if it is clogged.
Replace the lter as follows:1.
Move the hose clamps away from the lter. Use 2.
at-nosed pliers.
Pull the lter loose from the hose ends.3.
Push the new lter into the hose ends. Position the 4.
lter with the “FLOW” arrow pointing up toward the
fuel pump. If necessary, a soap solution can be
applied to the lter ends to ease mounting.
Move the hose clamps back toward the lter.5.
8011-468
Fuel lter
Fuel Pump Air Filter
Regularly check that the fuel pump’s air lter is free
from dirt.
Remove the screws and open the pump, no hoses
need be removed.
The lter can be cleaned with a brush if necessary.
Replace the lter on the console.
8009-147
Fuel pump air lter
8009-181
Remove dust
Tap the paper lter against a xed surface to 4.
remove dust. If the paper lter is still dirty, it
must be replaced.
To ret lter:
Check that the seal on the bottom of the paper 1.
lter is whole.
Mount the paper lter in the air lter housing 2.
and tighten the wing nuts.
Ret the pre-lter on the paper lter.3.
Replace the cowling over the air lter housing. 4.
Do not over tighten the plastic fastener.