EasyManua.ls Logo

Husqvarna GTH24V54 - User Manual

Husqvarna GTH24V54
72 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
English/French
586 30 90-24
Operator’s Manual
Manuel de L’Opérateur
GTH24V54
Gasoline containing up to 10% ethanol (E10) is accept-
able for use in this machine. The use of any gasoline ex-
ceeding 10% ethanol (E10) will void the product warranty.
Vous pouvez utiliser de l’essence contenant jusqu’à
10 % d’éthanol (E10) avec cet appareil. L’utilisation
d’essence contenant plus de 10 % d’éthanol annulera
la garantie du produit.
Please read the operator's manual carefully and make sure
you understand the instructions before using the machine.
Lisez très attentivement et soyez certain de comprende
ces instructions avant d’utiliser cette machine.

Table of Contents

Questions and Answers

  • P
    Patricia BriggsAug 19, 2025
    How to fix a Husqvarna GTH24V54 Lawn Mower that will not start?
    • B
      Brandon WardAug 19, 2025
      If your Husqvarna Lawn Mower won't start, there are several potential causes. First, check if you are out of fuel and fill the fuel tank if necessary. If the engine is flooded, wait a few minutes before trying again. Other possible issues include a bad spark plug (replace it), a dirty air filter (clean or replace it), a dirty fuel filter (replace it), or water in the fuel (empty the fuel tank and carburetor, refill with fresh gasoline, and replace the fuel filter). Also, check for loose or damaged wiring. If none of these steps work, the engine valves may be out of adjustment, requiring you to contact an authorized service center.
  • M
    Marissa MannAug 21, 2025
    Why won't my Husqvarna GTH24V54 engine turn over?
    • S
      Steven GarrettAug 22, 2025
      If your Husqvarna Lawn Mower engine will not turn over, make sure the brake pedal is depressed and the attachment clutch is disengaged. Other potential causes include a weak or dead battery (recharge or replace it), a blown fuse (replace it), corroded battery terminals (clean them), or loose or damaged wiring (check all wiring). Also, check or replace the ignition switch, solenoid, or starter if they are faulty. If the issue persists, there may be a faulty operator presence switch, which requires contacting an authorized service center.
  • T
    Timothy GarzaAug 25, 2025
    Why is my Husqvarna GTH24V54 hard to start?
    • M
      melissagarciaAug 25, 2025
      If your Husqvarna Lawn Mower is hard to start, the issue could be due to a dirty air filter (clean or replace it), a bad spark plug (replace it), a weak or dead battery (recharge or replace it), or a dirty fuel filter (replace it). Stale or dirty fuel may also be the culprit; in this case, empty the fuel tank and refill it with fresh, clean gas. Also, check for loose or damaged wiring. If the problem persists, the engine valves may be out of adjustment, and you should contact an authorized service center.
  • H
    Heather BookerAug 28, 2025
    Why is the cut from my Husqvarna GTH24V54 poor and uneven?
    • J
      John BlackAug 28, 2025
      An uneven cut with your Husqvarna Lawn Mower can be due to a worn, bent, or loose blade (replace the blade and tighten the blade bolt), a mower deck that is not level (level the mower deck), a buildup of grass, leaves, or trash under the mower (clean the underside of the mower housing), a bent blade mandrel (replace the blade mandrel), or clogged mower deck vent holes (clean around mandrels to open vent holes).
  • E
    Emily GrayAug 30, 2025
    What causes the battery of my Husqvarna GTH24V54 Lawn Mower not to charge?
    • R
      Ryan RussellAug 30, 2025
      If the battery on your Husqvarna Lawn Mower will not charge, it could be due to bad battery cells (replace the battery), poor cable connections (check and clean all connections), a faulty regulator (if equipped, replace the regulator), or a faulty alternator (replace the alternator).
  • S
    Stephen ParrishSep 1, 2025
    How to stop my Husqvarna GTH24V54 engine from backfiring when turning it off?
    • J
      johnsonbillySep 1, 2025
      If your Husqvarna Lawn Mower engine "backfires” when turning the engine “OFF”, move the throttle control between half and full speed (fast) position before stopping the engine.
  • S
    Stephen MillerSep 3, 2025
    What to do if Husqvarna Lawn Mower engine clicks but will not start?
    • J
      Jason ParkerSep 3, 2025
      If the Husqvarna Lawn Mower engine clicks but doesn't start, possible causes include a weak or dead battery (recharge or replace), corroded battery terminals (clean them), loose or damaged wiring (check the wiring), or a faulty solenoid or starter (check or replace these).
  • C
    Christine MendezSep 5, 2025
    What causes excessive vibration in a Husqvarna Lawn Mower?
    • H
      Holly SilvaSep 6, 2025
      Excessive vibration in your Husqvarna Lawn Mower can be caused by a worn, bent, or loose blade (replace the blade and tighten the blade bolt), a bent blade mandrel (replace the blade mandrel), or loose or damaged parts (tighten loose parts and replace damaged parts).
  • M
    mosslynnSep 10, 2025
    What to do if the headlight(s) are not working on my Husqvarna GTH24V54?
    • M
      Matthew JimenezSep 10, 2025
      If the headlight(s) on your Husqvarna Lawn Mower are not working, first check if the switch is “OFF” and turn it “ON”. If that doesn't work, the bulb(s) or lamp(s) may be burned out (replace them). Other possible causes include a faulty light switch (check or replace it), loose or damaged wiring (check the wiring and connections), or a blown fuse (replace the fuse).
  • S
    Stephanie NelsonSep 12, 2025
    Why won't the mower blades rotate on my Husqvarna Lawn Mower?
    • J
      jennifercherrySep 12, 2025
      If the mower blades on your Husqvarna Lawn Mower will not rotate, it could be due to an obstruction in the clutch mechanism (remove the obstruction), a worn or damaged mower drive belt (replace the mower drive belt), a frozen idler pulley (replace the idler pulley), or a frozen blade mandrel (replace the blade mandrel).

Husqvarna GTH24V54 Specifications

General IconGeneral
Engine Power24 HP
Cutting Width54 inches
Transmission TypeHydrostatic
Deck MaterialSteel
Weight600 lbs
Engine TypeV-Twin
Engine Displacement724 cc
Turning Radius16 inches
Warranty3 years
Engine BrandBriggs & Stratton
Cutting Height1.5 - 4 inches

Related product manuals