EasyManua.ls Logo

Husqvarna GTH26V48LS - User Manual

Husqvarna GTH26V48LS
48 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
03002
GTH26V48LS
Owner's Manual / 96043009000 / 2009-12
532 43 27-87

Table of Contents

Questions and Answers

  • S
    soliverAug 3, 2025
    Why won't the engine on my Husqvarna GTH26V48LS turn over?
    • A
      Antonio TorresAug 3, 2025
      If the engine on your Husqvarna Lawn Mower will not turn over, make sure the brake pedal is fully depressed. Also, ensure that the attachment clutch is disengaged. If these aren't the issue, check the battery; a weak or dead battery may need recharging or replacement. A blown fuse can also prevent the engine from turning over, so replace it if necessary. Corroded battery terminals can impede the flow of electricity, so clean them. Inspect all wiring for any loose connections or damage. If the problem persists, the ignition switch, solenoid, or starter might be faulty and need checking or replacement. For issues with the operator presence switch(es), it is recommended to contact an authorized service center/department.
  • L
    Lawrence JohnsonAug 13, 2025
    How to troubleshoot a Husqvarna GTH26V48LS that is hard to start?
    • R
      Robert GloverAug 13, 2025
      If your Husqvarna Lawn Mower is hard to start, several factors could be contributing. A dirty air filter can restrict airflow, so try cleaning or replacing it. A bad spark plug is another common cause, so replace it if necessary. A weak or dead battery won't provide enough power, so recharge or replace the battery. Also, a dirty fuel filter can impede fuel flow, so replace it. Stale or dirty fuel can also cause starting issues; empty the fuel tank and refill it with fresh, clean gas. Loose or damaged wiring can prevent proper electrical function, so check all wiring. If these steps don't resolve the issue, the carburetor or engine valves might need adjustment, requiring professional assistance.
  • J
    Jason GarrettAug 18, 2025
    What to do if my Husqvarna GTH26V48LS engine clicks but will not start?
    • J
      james01Aug 18, 2025
      If your Husqvarna Lawn Mower engine clicks but won't start, it often points to electrical issues. The most common cause is a weak or dead battery, so recharge or replace it. Corroded battery terminals can also prevent a good connection, so clean them thoroughly. Check all wiring for looseness or damage, as this can disrupt the electrical circuit. Lastly, a faulty solenoid or starter could be the problem, in which case you should check or replace them.
  • C
    charles35Aug 25, 2025
    What causes excessive vibration in a Husqvarna GTH26V48LS?
    • L
      lkellyAug 25, 2025
      Excessive vibration in your Husqvarna Lawn Mower can stem from several issues. Check the blade for wear, bends, or looseness; replace it if necessary and tighten the blade bolt. A bent blade mandrel can also cause vibration, so replace it. Additionally, inspect for any loose or damaged parts, tightening or replacing them as needed.
  • V
    Vincent ReevesOct 28, 2025
    How to fix a Husqvarna GTH26V48LS that will not start?
    • Z
      zachary78Oct 28, 2025
      If your Husqvarna Lawn Mower won't start, several factors could be at play. It might be out of fuel, so start by filling the fuel tank. If that's not the issue, make sure the engine is choked properly, referring to the 'TO START ENGINE' section. An engine flood could also be the culprit; wait a few minutes before trying again. Other potential causes include a bad spark plug (replace it), a dirty air filter (clean or replace it), or a dirty fuel filter (replace it). Water in the fuel can also prevent starting; if this is the case, empty the fuel tank and carburetor, refill with fresh gasoline, and replace the fuel filter. Finally, check all wiring for looseness or damage. If these steps don't resolve the issue, the carburetor or engine valves might need adjustment, requiring professional as...
  • K
    Kimberly SullivanNov 7, 2025
    Why is my Husqvarna Lawn Mower losing power?
    • S
      Sara ThompsonNov 7, 2025
      If your Husqvarna Lawn Mower experiences a loss of power, consider these potential causes and solutions. If you are cutting too much grass or moving too fast, raise the cutting height or reduce your speed. Check that the throttle isn't in the 'CHOKE' position and adjust it accordingly. A build-up of grass, leaves, or trash under the mower can also cause power loss; clean the underside of the mower housing. Additionally, a dirty air filter (clean or replace it), low or dirty oil (check and change it), or a faulty spark plug (clean, regap, or change it) could be responsible. Other factors include a dirty fuel filter (replace it), stale or dirty fuel (empty and refill the tank with fresh gas), or water in the fuel (empty the tank and carburetor, refill with fresh gasoline, and replace the fue...

Summary

SAFETY RULES

GENERAL OPERATION

Follow all safety rules and instructions before starting. Keep clear of moving parts.

SLOPE OPERATION

Exercise extra caution on slopes. Mow up and down, not across. Avoid sudden turns.

SAFETY RULES CONTINUED

CHILDREN AND TOWING SAFETY

Keep children clear and follow towing guidelines carefully.

SERVICE AND GASOLINE HANDLING

OPERATION BASICS

UNDERSTANDING SYMBOLS AND HAZARDS

KNOWING YOUR TRACTOR CONTROLS

Familiarization with tractor controls, adjustments, and their functions.

OPERATING THE TRACTOR

STARTING AND STOPPING PROCEDURES

MOVEMENT AND CUTTING ADJUSTMENTS

Controlling forward/reverse movement, cruise control, and mower cutting height.

OPERATION - ADVANCED

REVERSE OPERATION AND HILLS

Using ROS and operating safely on slopes.

OPERATION - STARTING ENGINE

PRE-START CHECKS AND FUELING

Checking oil, adding gasoline, and understanding fuel valve.

ENGINE STARTING PROCEDURES

Starting the engine in various conditions and warm-up procedures.

OPERATION - MOWING AND TRANSMISSION

TRANSMISSION PURGING AND MOWING TIPS

MAINTENANCE SCHEDULE AND GUIDELINES

MAINTENANCE SCHEDULE

A schedule outlining maintenance tasks by usage hours or time.

BEFORE EACH USE AND LUBRICATION

MAINTENANCE - TRACTOR AND BLADES

TRACTOR, BRAKE, AND TIRE MAINTENANCE

SAFETY SYSTEMS, BLADE CARE, AND BATTERY

Checking safety systems, blade care, and battery maintenance.

MAINTENANCE - BELTS, TRANSAXLE, AND ENGINE

ENGINE FILTERS, COOLING, MUFFLER, AND SPARK PLUGS

SERVICE AND ADJUSTMENTS - MOWER

SERVICE SAFETY PRECAUTIONS

Critical safety precautions before performing service.

MOWER REMOVAL AND INSTALLATION

SERVICE AND ADJUSTMENTS - MOWER LEVELING

MOWER LEVELING PROCEDURES

Instructions on how to level the mower deck for optimal cutting.

SIDE-TO-SIDE AND FRONT-TO-BACK ADJUSTMENTS

SERVICE AND ADJUSTMENTS - BELTS AND BRAKES

MOWER BELT REPLACEMENT

BRAKE SYSTEM CHECK

SERVICE AND ADJUSTMENTS - BATTERY

JUMP-STARTING WITH A WEAK BATTERY

REPLACING THE TRACTOR BATTERY

TROUBLESHOOTING GUIDE

ENGINE STARTING AND RUNNING ISSUES

CUTTING AND OPERATIONAL ISSUES

Husqvarna GTH26V48LS Specifications

General IconGeneral
ManufacturerHusqvarna
ProductGTH26V48LS
CategoryLawn Mower
Engine ManufacturerBriggs & Stratton
Engine Displacement724 cc
Horsepower26 hp
Cutting Width48 inches
Cutting Height, min1.5 inches
Transmission TypeHydrostatic
Speed Range0 - 5.5 mph
Fuel Capacity3.5 gallons
Deck MaterialSteel
Warranty3 years
Cutting Height, max4 inches
DriveRear-wheel drive
Weight650 lb

Related product manuals