English-50
MAINTENANCE
To adjust anti-scalp rollers
Anti-scalp rollers are properly adjusted when
they are just slightly off of the ground when
the deck is at the desired cutting height in the
operating position. Anti-scalp rollers then
keep the deck in the proper position to help
prevent scalping in most terrain conditions.
Tunnel Deck -
The anti-scalp rollers can be set in three
positions.
• Upper position 1.5” to 3” (38 to 76 mm)
grass.
• Middle position 3” to 4.5” (76 to 114 mm)
grass.
• Lower position 4.5” to 6” (114 to 152 mm)
grass.
Combi Deck -
The anti-scalp rollers can be set in two
postions.
• Upper position 1.5” to 3” (38 to 76mm)
grass.
• Lower position 3” to 5” (38 to 127mm)
grass.
The rollers should be approximately 1/4”
(6.5 mm) from ground.
CZ-9
Anti-scalp roller - Tunnel Decks
IMPORTANT INFORMATION
Adjust Anti-scalp rollers with the
mower on a flat level surface.
CZ-9
Anti-scalp roller - Combi Decks
IMPORTANT INFORMATION
The anti-scalp rollers must not be used for
gauge wheels or the roller and deck may
be damaged.
To Next Page
Loading...
