To Next PageTo Next Page
Need help?Do you have a question about the Husqvarna K1200 MARK II and is the answer not in the manual?
Identifies symbols used in the operator's manual for clarity.
Identifies symbols present on the power cutter itself for operational guidance.
Critical warnings regarding machine hazards, fuel, and protective measures.
Ensures operator is fit, trained, and adheres to service guidelines.
Specifies required safety gear for operator protection.
Covers machine setup, operation techniques, guards, and environmental safety.
Guidelines for safe fuel management and refueling procedures.
Ensures safety of others and the work environment.
Identifies the cutter disc and protective guard.
Identifies the starter assembly and fuel tank components.
Instructions for fitting, reversing, and adjusting the cutter arm.
Procedures for fitting, tensioning, and replacing the drive belt.
Proper method for mounting and tightening the cutting wheel.
Steps for securing the spindle and adjusting the wheel guard.
Critical guidance on fuel type, mixing, and safe refueling.
Procedures for cleaning and replacing the fuel filter.
Identification and function of machine controls.
Step-by-step guide for safe engine starting procedures.
Instructions for replacing the starter cord assembly.
Procedures for safely replacing the starter recoil spring.
Description of filter components for different models.
Importance of correct filter maintenance to prevent engine damage.
Factory settings for idle and high speed needles.
Procedures for adjusting idle and high speed needles.
Final steps to set the idle speed correctly.
Guidance on checking, cleaning, and selecting the correct spark plug.
Techniques for cutting steel and other metals effectively.
Techniques for cutting stone, concrete, with dust suppression.
Checklist for operator preparedness before using the machine.
Checklist for safe operation, starting, cutting, and storage.
Guidelines for handling and storing cutter wheels safely.
General