To Next PageTo Next PageWhy does my Husqvarna Lawn Mower keep stopping?
If your Husqvarna Lawn Mower stops, it could be due to a weak battery. In this case, charge the battery. Another potential cause is a battery connector failure, so you should examine the battery connector.
What does it mean when the error LED flashes on my Husqvarna Lawn Mower?
If the error LED is flashing on your Husqvarna Lawn Mower, it could indicate several issues. The battery might be weak, so try charging it. Also, the temperature in the work environment could be too high or too low. Make sure to use the battery in temperatures between -10°C and 40°C. Overvoltage could also be a factor; check that the mains voltage matches the rating plate on the product. If none of these, remove the battery from the charger, wait 5 seconds, and try charging again. If the problem persists, contact an authorized service agent.
What to do if the error LED flashes on my Husqvarna LC 141i?
If the error LED on your Husqvarna Lawn Mower is flashing and the motor is overloaded, try increasing the cutting height. If that doesn't work, stop the motor and wait for it to cool down. Also, check if the blade is blocked and ensure it can rotate freely after turning the safety key to 0 and removing the battery for at least 5 seconds. If the error continues, contact an authorized service agent. Also, ensure the battery is correctly inserted and check the battery connector. If the error LED on the battery flashes, consult the Battery section on page 22.
What to do for battery error or no signal from battery in Husqvarna LC 141i?
Put the battery in the Husqvarna Lawn Mower correctly and examine the battery connector.
How to fix a flashing green LED on my Husqvarna LC 141i Lawn Mower?
If the green LED is flashing on your Husqvarna Lawn Mower, the battery voltage is low. Charge the battery to resolve this issue.
How to fix a flashing green LED on a Husqvarna LC 141i Lawn Mower?
If the green LED is flashing on your Husqvarna Lawn Mower, it means the battery voltage is low. You should charge the battery.
What to do if the Husqvarna LC 141i Lawn Mower stops?
If your Husqvarna Lawn Mower stops, the battery may be weak, so charge it. Also, examine the battery connector for any issues.
Why is the error LED flashing on my Husqvarna LC 141i?
The error LED on your Husqvarna Lawn Mower might be flashing because the battery is weak, so try charging it. Another reason could be that the temperature in your work environment is too high or too low; use the battery in temperatures between -10°C and 40°C. Also, overvoltage can cause this problem, so make sure that the mains voltage is the same as on the rating plate on the product. If none of these solutions work, remove the battery from the battery charger, wait 5 seconds, and try charging the battery again.
What to do if the motor control of my Husqvarna LC 141i is too hot?
If the motor control of your Husqvarna Lawn Mower gets too hot, stop the motor and wait until it cools down.
What to do if the blade is blocked on my Husqvarna LC 141i?
To address a blocked blade on your Husqvarna Lawn Mower, turn the safety key to 0, remove the battery, and wait at least 5 seconds to prevent accidental starts. Check to ensure the blade can rotate freely.
General| Cutting Width | 41 cm |
|---|---|
| Cutting Height, min-max | 25-75 mm |
| Battery Voltage | 36 V |
| Collector Volume | 50 L |
| Drive System | Push |
| Cutting Height Adjustment | Central |
| Max Runtime | 40 min |
| Battery Capacity | 4 Ah |
| Wheel Size | 170/200 mm |
| Motor Type | BLDC (Brushless) |
| Engine Type | Brushless |
