Husqvarna LC 142iS - User Manual

Questions and Answers

K
kevinbrownAug 17, 2025
What to do if the Error LED flashes and my Husqvarna LC 142iS Lawn Mower stops?
- S
  Sara LewisAug 17, 2025
  If the error LED flashes and the Husqvarna Lawn Mower stops, there could be several reasons. It could be due to a battery connector failure, so you should examine the battery connector. The motor may be overloaded, so try increasing the cutting height. If the battery is weak, charge it. Also, ensure the battery is correctly placed and examine the connector if there's a battery error or no signal. If the motor brake handle was engaged before starting, release it, wait 5 seconds, and try again. If other errors occur, remove the battery and consult a service agent.
W
wcostaAug 20, 2025
What to do if Error LED flashes and Husqvarna LC 142iS does not operate correctly?
- E
  Elizabeth OsborneAug 20, 2025
  If the Error LED flashes and the Husqvarna Lawn Mower doesn't operate correctly, the blade might be blocked. Turn the safety key to 0, remove the battery, wait 5 seconds, and clear any obstacles to ensure the blade rotates freely. The motor speed may be dropping too much, so increase the cutting height. Also, check if the wheels or transmission are blocked, and remove any obstructions. If the motor control is too hot, stop the motor and allow it to cool down.
C
Carol GreenAug 22, 2025
What to do if the Error LED flashes and the Husqvarna Lawn Mower stops?
- J
  Justin ElliottAug 23, 2025
  If the error LED flashes and the product stops, there could be several reasons: * **Battery connector failure:** Examine the battery connector. * **Motor overload:** Increase the cutting height. * **Weak battery:** Charge the battery. * **Battery error or no signal:** Ensure the battery is correctly inserted and examine the battery connector. If the error LED on the battery flashes, refer to the Battery charger section. * **Incorrect start:** Release the motor brake handle, wait about 5 seconds, and then push it down again to start the product.
G
George EstradaAug 26, 2025
What to do if the Error LED flashes on my Husqvarna Lawn Mower and it doesn't operate correctly?
- K
  Katherine WarnerAug 26, 2025
  If the error LED flashes and the product doesn't operate correctly, it could be due to the following reasons: * **Blade blockage:** Turn the safety key to 0, remove the battery, wait 5 seconds, and clear any obstacles to ensure the blade rotates freely. If the problem persists, contact an approved service agent. * **Motor speed drop:** Increase the cutting height.
M
michaelharrisonAug 28, 2025
Why is the error LED flashing on my Husqvarna Lawn Mower?
- B
  byoungAug 28, 2025
  If the error LED flashes on your Husqvarna Lawn Mower, the battery may be weak, so you should charge it. The temperature in the work environment may be too high or too low; use the battery in temperatures between 5 °C - 40 °C. There may be overvoltage, so make sure that the mains voltage is the same as on the rating plate on the product. You can also try removing the battery from the charger, waiting 5 seconds, and trying again. If the problem continues, speak to a service agent.
S
Stephanie ChristensenAug 31, 2025
What does it mean when the error LED is on on my Husqvarna LC 142iS?
- S
  Stephanie MontgomeryAug 31, 2025
  If the error LED is on for your Husqvarna Lawn Mower, it could indicate that the cell difference is too much (1V). In this case, you should speak to an approved service agent.
J
Joseph PetersonSep 3, 2025
How to fix a flashing green LED on a Husqvarna LC 142iS?
- A
  Audrey MorganSep 3, 2025
  If the green LED flashes on your Husqvarna Lawn Mower, the battery voltage is likely low. Charge the battery to resolve this issue.
L
Luis MartinezSep 5, 2025
Why does the Error LED flash on my Husqvarna LC 142iS?
- J
  Judith GomezSep 5, 2025
  The error LED flashing indicates a problem. The possible causes are: * The battery is weak, so you should charge the battery. * The temperature is not optimal, so use the battery in temperatures between 5 °C - 40 °C. * There is overvoltage, so make sure that the mains voltage is the same as on the rating plate on the product. * If the problem continues, remove the battery from the battery charger, wait 5 seconds and try again to charge the battery. If it still does not work, speak to an approved service agent.
A
Allison SullivanSep 8, 2025
What to do if the Error LED is on for Husqvarna LC 142iS Lawn Mower?
- L
  Lauren SmithSep 8, 2025
  The error LED being on indicates that the cell difference is too much (1V). In this case, speak to an approved service agent.
S
Spencer JacksonSep 12, 2025
Why is the green LED flashing on my Husqvarna Lawn Mower?
- H
  Heidi KennedySep 12, 2025
  The green LED flashes because the battery voltage is low. Charge the battery.

Husqvarna LC 142iS Specifications

General

Cutting Width	42 cm
Cutting Height	25-75 mm
Battery Voltage	36 V
Collector Volume	50 L
Cutting Height Adjustment	Central
Grass Collection	Yes
Type	Walk behind lawn mower
Engine Type	Battery
Starting System	Electric