Husqvarna LC 247S - User Manual

Other manuals for Husqvarna LC 247S

Workshop Manual20 pages

Questions and Answers

T
Tammy ObrienAug 7, 2025
Why won't my Husqvarna Lawn Mower engine start?
- R
  Robert MorseAug 7, 2025
  If your Husqvarna Lawn Mower engine won't start, several factors could be at play. First, ensure the ignition cable is correctly connected to the spark plug. If that's not the issue, check the fuel tank; it might be empty and need refilling with the correct fuel type. Old fuel can also be a culprit, so drain the tank and carburetor and refuel with fresh gasoline. A dirty carburetor or fuel line can also prevent starting, requiring cleaning. Lastly, inspect the spark plug for defects—adjust the electrode gap, clean, or replace it as needed. If there is fuel on the spark plug, clean it.
J
Jacob BrooksAug 11, 2025
How to fix a Husqvarna LC 247S engine that does not operate smoothly?
- T
  thompsonfrankAug 11, 2025
  If your Husqvarna Lawn Mower engine isn't operating smoothly, it could be due to several reasons. Check that the ignition cable is correctly connected to the spark plug. Also, the fuel line might be dirty, or the fuel might be old; in this case, clean the fuel line and refill the fuel tank with new fuel of the correct type. A blocked fuel tank cap can also cause issues, so ensure it's clean. Water or dirt in the fuel system can also be responsible; drain the fuel tank and refill with new fuel. A dirty air filter can also cause the engine to run rough, so clean it. If these steps don't resolve the issue, a servicing dealer may need to adjust the carburetor.
S
Samantha LewisAug 16, 2025
Why is my Husqvarna Lawn Mower engine becoming too hot?
- T
  thomasdavidAug 16, 2025
  If your Husqvarna Lawn Mower engine is overheating, it could be due to a low engine oil level. Make sure to fill the engine oil to the correct level. Insufficient airflow can also cause overheating, so clean the air filter and the air filter housing. If the problem persists, a servicing dealer may need to adjust the carburetor.
E
elizabeth41Aug 22, 2025
What to do if my Husqvarna LC 247S engine does not stop?
- C
  Chelsea JohnsonAug 22, 2025
  If the Husqvarna Lawn Mower engine continues to run, disconnect the ignition cable from the spark plug and let an approved service agent repair the product because the stop mechanism is defective.
S
Stephanie Guzman MDAug 27, 2025
How to fix misfire in Husqvarna LC 247S engine at high speed?
- M
  Morgan EdwardsAug 27, 2025
  If you're experiencing misfire in your Husqvarna Lawn Mower engine at high speed, the electrode gap in the spark plug might be too small. Adjust the electrode gap to resolve this.
J
Joshua ClarkAug 31, 2025
How to troubleshoot a Husqvarna LC 247S Lawn Mower engine that doesn't operate smoothly at idle speed?
- M
  marthalambertSep 1, 2025
  If the Husqvarna Lawn Mower engine does not operate smoothly at idle speed, it could be due to several reasons. The spark plug might be dirty or defective, or the electrode gap might be too wide, so adjust the electrode gap or replace the spark plug. The carburetor may need adjustment. Also, a dirty air filter can cause this issue, so clean the air filter.

Summary

Safety

Safety Definitions and General Instructions

Operational Safety Precautions

Covers safety for work area, general operation, PPE, and product safety devices.

Specific Safety Topics

Addresses critical safety measures for fuel handling and during maintenance procedures.

Assembly

Operation

Pre-Operation Checks and Setup

Essential checks, refueling, and cutting height adjustment before starting the mower.

Starting and Driving the Mower

Procedures for starting the engine, engaging the drive, and stopping the mower.

Achieving Optimal Cutting Results

Maintenance

Maintenance Schedule and General Checks

Engine Components Maintenance

Tasks related to engine oil, spark plug, air filter, and fuel system checks and replacements.

Cutting System and Drive Adjustment

Engine Troubleshooting

Technical Data

Husqvarna LC 247S Specifications

General

Engine manufacturer	Briggs & Stratton
Engine name	450e Series
Engine model	450e
Net power RPM	2900 rpm
Cutting methods	Collection/Rear discharge
Cutting width	47 cm
Cutting height steps	6
Cutting height adjustment	Central
Cutting height max	75 mm
Cutting height min	20 mm
Cutting height	20-75 mm
Drive system	Self-propelled, single speed
Collector type	Fabric with dust blocker
Grass collector	Yes
Weight	30 kg
Wheels	Yes
Wheel size, Front	170 mm
Wheel size, Rear	210 mm
Start type	Recoil
Cylinder displacement	125 cm³
Displacement	125 cm³
Collector volume	55 l