English – 15
MAINTENANCE
Cleaning cutting cover
• Connect a water hose to the cutting cover connection.
• Start the engine and let the blade rotate for a while. The
w
ater is thrown out and cleaning the cutting cover.
Adjusting the clutch wire
The clutch wire is adjusted by turning the adjustment screw.
Below you will find some general maintenance
instructions.
Daily maintenance
1 Check that the engine brake handle works safely.
2 Brush leaves, grass and the like off of the lawn mower.
3 Check the oil level.
4 Clean the air intake on the starter. Check the starter and
star
ter cord.
5 Check that nuts and screws are tight.
6 Check the cutting attachment. Never use blades that are
dull, cr
acked or damaged.
Weekly maintenance
1 Clean the air filter. Replace if necessary.
2 Clean the spark plug. Check that the electrode gap is 0.51
mm.
3 Clean the cooling fins on the cylinder.
At least once a year
1 Carry out annually service at authorised dealer (at least
once a year or every 30 hours).
To Next Page
Loading...
