To Next PageTo Next Page
Need help?Do you have a question about the Husqvarna M-ZT 52 and is the answer not in the manual?
General| Engine Manufacturer | Kawasaki |
|---|---|
| Engine Power | 23 hp |
| Cutting Width | 52 inches |
| Cutting Height | 1.5 - 4.5 inches |
| Cutting Deck Material | Steel |
| Transmission Type | Hydrostatic |
| Weight | 770 lbs |
| Turning Radius | Zero-turn |
| Seat Type | High Back |
| Warranty | 3 years |
| Fuel Capacity | 5 gallons |
Covers for the machine frame, available in left and right configurations.
Component for mounting the battery onto the machine frame.
Various screws and nuts used for assembling the frame components.
Components related to the engine's idler pulley system for belt tensioning.
The engine's clutch mechanism, rated for 200 foot-pounds of torque.
The belt used for power transmission from the engine.
The control levers for steering, including grips.
Brackets that support and mount the steering control mechanisms.
Rods that transmit motion from the steering controls to the steering system.
The main switch for starting and stopping the engine, and the associated key.
The complete fuel tank system, including mounting and cap.
The battery and associated cables for the ignition system.
The main lever and arm components of the parking brake system.
The cables that connect the brake lever to the braking mechanism.
A switch that may activate or indicate the parking brake status.
The left and right hydraulic transmissions for the machine.
The filter unit for the hydraulic fluid system.
Mounting brackets for the hydraulic transmission units.
Complete wheel and tire units for caster and rear positions.
Bearings used within the wheel hubs for smooth rotation.
Grease fittings for lubrication points on the wheel assemblies.
Components forming the mechanical linkage for raising and lowering the deck.
Pivoting levers used in the deck lift mechanism.
Spring providing tension or assistance to the deck lift system.
The cutting blades for the mower deck, specified at 18 inches.
The main structural housing of the mower deck.
Idler pulleys used on the mower deck for belt routing.
The complete seat unit, including padding and frame.
Components for attaching the seat belt to the seat or chassis.
Springs used for seat suspension or adjustment.
Decals providing warnings, safety instructions, and operational information.
Decals indicating the machine model and manufacturer branding.
Decals related to the operation of motion controls.
The upper section of the Roll-Over Protection Structure.
The vertical side support tubes for the ROPS.
High-tensile screws, nuts, and washers used to assemble the ROPS.
Baffles for the mulch kit, directing clippings.
Specialized blades designed for mulching grass clippings.
A cover or cap associated with the mulch kit installation.
