EasyManuals Logo

Husqvarna MZ 52 User Manual

Husqvarna MZ 52
64 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #51 background imageLoading...
Page #51 background image
51
STORAGE
Winter Storage
The machine should be readied for storage at the
end of the mowing season or if it will not be in use for
longer than 30 days.
Fuel allowed to stand for long periods of time (30 days
or more) can leave sticky residues that can plug the
carburetor and disrupt engine function.
Fuel stabilizers are an acceptable option as regards
to the sticky residues that can occur during storage.
Add stabilizer to the fuel in the tank or in the storage
container. Always use the mixing ratios specified by
the manufacturer of the stabilizer. Run the engine for
at least 10 minutes after adding the stabilizer so that
it reaches the carburetor. Do not empty the fuel tank
and the carburetor if a stabilizer has been added.
To ready the machine for storage, follow these steps:
1. Thoroughly clean the machine, especially under
the mower deck. Touch up damage to the paint
and spray a thin layer of oil on the underside of
the mower deck to avoid corrosion.
2. Inspect the machine for worn or damaged parts
and tighten any nuts or screws that may have
become loose.
3. Change the engine oil; dispose of properly.
4. Empty the fuel tanks or add a fuel stabilizer. Start
the engine and allow it to run until the carburetor
is drained of fuel or the stabilizer has reached the
carburetor.
5. Remove the spark plug and pour about a
tablespoon of engine oil into the cylinder. Turn
over the engine so that the oil is evenly distributed
and then refit the spark plug.
6. Lubricate all grease zerks, joints, and axles.
7. Remove the battery. Clean, charge, and store the
battery in a cool place, but protect it from direct
cold.
8. Store the machine in a clean, dry place and cover
it for extra protection.
Service
When ordering spare parts, please specify the
purchase year, model, type, and serial number.
Always use genuine Husqvarna spare parts.
An annual check-up at an authorized service
workshop is a good way to ensure that the machine
performs its best the following season.
WARNING!
Never store an engine with fuel in the
tank indoors or in poorly ventilated
spaces where fuel vapor can come
in contact with open flames, sparks,
or a pilot light such as in a boiler, hot
water tank, clothes dryer, etc. Handle
the fuel with care. It is very flammable
and can cause serious personal injury
and property damage. Drain the fuel
outdoors, into an approved container.
Store the fuel away from open flame
or any source of ignition. Never use
gasoline for cleaning. Use a degreaser
and warm water.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Husqvarna MZ 52 and is the answer not in the manual?

Husqvarna MZ 52 Specifications

General IconGeneral
Engine ManufacturerKawasaki
Engine NameFR Series
Engine Power23 hp
Cutting Width52 inches
Cutting Deck TypeFabricated
Deck Thickness10 gauge
Cutting Height1.5 - 4.5 inches
Deck MaterialSteel
Transmission TypeHydrostatic
Weight770 lbs
Cutting MethodsCollection/Mulching/Side discharge
Fuel Tank Volume5 US gal
Fuel Capacity5 US gal
Seat TypeHigh back
Turning Radius0 inches

Related product manuals