MAINTENANCE
Anti=scalp rollers
Anti-scalp rollers are properly adjusted when they are
just slightly off of the ground when the deck is at the
desired cutting height in the operating position. Anti-
scalp rollers then keep the deck in the proper position
to help prevent scalping in most terrain conditions,
IMPORTANT INFORMATION
Adjust anti-scalp rollers with the mower on a
flat level surface.
Anti-scalp rollers can be set in three positions:
• Upper position 11/2to 3" (38 to 76 mm) grass.
• Middle position 3" to 41/2'' (76 to 114 mm) grass.
• Lower position 41/2''to 6" (114 to 152 mm) grass.
The rollers should be approximately 1/4"(6.5 mm) from
ground, Do not adjust the rollers to support the deck,
Anti-scalp rollers
8058-054
IMPORTANT INFORMATION
To avoid deck damage, the anti-scalp rollers
must not be adjusted to support the deck.
43
To Next Page
Loading...
