43
MAINTENANCE
Anti-scalp rollers
Anti-scalp rollers are properly adjusted when they are
just slightly off of the ground when the deck is at the
desired cutting height in the operating position. Anti-
scalp rollers then keep the deck in the proper position
to help prevent scalping in most terrain conditions.
IMPORTANT INFORMATION
Adjust anti-scalp rollers with the mower on a
flat level surface.
IMPORTANT INFORMATION
To avoid deck damage, the anti-scalp rollers
must not be adjusted to support the deck.
Anti-scalp rollers can be set in three positions:
• Upper position 1 to 2½" (25 to 63 mm) grass.
• Middle position 2½" to 4" (63 to 102 mm) grass.
• Lower position 4" to 5" (102 to 127 mm) grass.
The rollers should be approximately ¼" (6.5 mm) from
ground. Do not adjust the rollers to support the deck.
8058-054
Anti-scalp rollers
To Next Page
Loading...
