Husqvarna PP65 - KEY TO SYMBOLS; Symbols on the machine; Explanation of warning levels

KEY T O SYMBOLS
2 – English
Symbols on the mac hine
W ARNING! The machine can be a
dangerous tool if used incorrectly or
carelessly, which can cause serious or
fatal injury to the operator or others.
Please read the operator’s manual
carefully and make sure you understand
the instructions before using the
machine.
Always wear:
• Approved protective helmet
• Approved hearing protection
• Protective goggles or a visor
• Breathing mask
Inspection and/or maintenance should
be carried out with the motor switched off
and the plug disconnected.
This product is in accordance with
applicable EC directives.
En vironmental marking. Symbols on
the product or its packaging indicate that
this product cannot be handled as
domestic waste. It must instead be
submitted to an appropriate recycling
station for the recovery of electrical and
electronic equipment.
By ensuring that this product is taken care of correctly,
you can help to counteract the potential negative impact
on the environment and people that can otherwise result
through the incorrect waste management of this product.
For more detailed information about recycling this
product, contact your municipality, your domestic waste
service or the shop from where you purchased the
product.
Other symbols/decals on the mac hine refer to special
certification requirements for certain markets.
Explanation of warning le vels
The w arnings are graded in three levels.
W ARNING!
CAUTION!
NOTICE!
!
W ARNING! Used if there is a risk of
serious injury or death for the operator
or damage to the surroundings if the
instructions in the manual are not
followed.
!
CA UTION! Used if there is a risk of injury
to the operator or damage to the
surroundings if the instructions in the
manual are not followed.
NO TICE! Used if there is a risk of damage to materials
or the machine if the instructions in the manual are not
followed.