To Next PageTo Next Page
Need help?Do you have a question about the Husqvarna R 152SVH-BBC and is the answer not in the manual?
General| Engine | Briggs & Stratton |
|---|---|
| Cutting Height Adjustment | Central |
| Drive Type | Self-propelled |
| Engine Manufacturer | Briggs & Stratton |
| Net Power at Preset RPM | 2.6 kW |
| Engine Displacement | 161 cm³ |
| Cutting Height | 25 - 75 mm |
Read instructions, understand controls, and proper use of equipment.
Inspect area, wear protective clothing, handle fuel safely, check machine parts.
Operate in well-lit, safe areas; avoid wet grass; proper technique on slopes.
Keep machine tight, store safely, cool engine, keep clean, check catcher.
Learn and understand the meaning of symbols on the machine or in literature.
Details on engine, dimensions, weight, noise, and vibration levels.
Identifies upper/lower handles, engine brake yoke, and starter components.
Identifies air filter, petrol intake, height adjust, throttle, and clutch controls.
Instructions on how to unfold and secure the handle using wing-nuts.
Steps to install the grass catcher frame into the bag and onto the mower housing.
Steps to remove the grass catcher and empty it, advising against dragging the bag.
Install grass catcher for rear bagging.
Close mulcher door for mulching.
Close mulcher door and install discharge guard for side discharge.
The mower can be set to different cutting levels.
Instructions on filling the engine with SAE30 oil, referring to motor instructions.
Steps for starting a cold or warm engine, including choke and throttle settings.
How to stop the engine by releasing the engine brake yoke.
How to use the clutch bar to engage/disengage the mower's drive.
Adjusting speed using the gear shift lever for different travel speeds.
Operating the blade clutch bar to engage or disengage the blade.
Do not use on slopes steeper than 15° to avoid engine lubrication issues.
Remove objects like twigs, toys, and stones before mowing.
Mow twice weekly, don't cut more than 1/3 of grass length, adjust height as needed.
Disconnect spark plug lead, tighten screws, check oil, keep spark plug at highest point when tilted.
Stop engine, unscrew dipstick, check level between FULL and ADD. Avoid overfilling.
Grind and balance cutter blade, disconnect spark plug, use gloves, get serviced professionally.
Change oil annually or after 25 hours, warm engine, drain old oil, fill with new SAE 30 oil.
Remove lid and filter cartridge for cleaning.
Rotate nut to tighten cable and increase ground speed.
If speed doesn't change, the drive belt is worn and needs replacement.
Remove spark plug lead, empty fuel and oil tanks before public transport.
