EasyManua.ls Logo

Husqvarna R 318X AWD - Operation Guide; Initial Setup and Adjustments

Husqvarna R 318X AWD
152 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
8. Hold the front edge of the cutting deck with two
hands and pull until it stops.
9. Lift the service lock to vertical position.
WARNING: The lock mechanism
can cause injury to fingers if you do
not operate it carefully. Hold the
front edge of the cutting deck with
two hands when you continue to the
next step.
10. Lift the front of the cutting deck until the service lock
touches the frame and pull the cutting deck out.
Operation
Introduction
WARNING: Before you operate the product,
you must read and understand the safety
chapter.
To start to use Husqvarna Connect
1. Download the Husqvarna Connect app on your
mobile device.
2. Register in the Husqvarna Connect app.
3. Do the instruction steps in the Husqvarna Connect
app to connect and register the product.
To fill fuel
WARNING: Gasoline is very flammable. Be
careful and refuel outdoors (see
Fuel safety
on page 11
).
WARNING: Do not use the fuel tank as a
support area.
CAUTION: Incorrect type of fuel can result in
engine damage.
The engine runs on gasoline with a minimum octane
rating of 91 RON (87 AKI), not mixed with oil. We
recommend biodegradable alkylate gasoline. Do not use
gasoline that contains more than 10% ethanol.
Do a check of the fuel level before each use and
refuel if necessary.
Do not fully fill the fuel tank. Keep a space of a
minimum 2.5 cm.
To adjust the seat
WARNING: Do not adjust the seat during
operation of the product.
1. To adjust the seat forward and rearward, put your
feet on the footrest plates.
2. Push the lever below the front edge of the seat, to
the side.
3. Move the seat to the position that is correct for you.
14 838 - 005 - 21.10.2019

Related product manuals