15. Hold the belt pulley with a counterhold and remove
the Allen screw that holds the belt pulley and engine
together. Refer to
Servicing tools on page 16
.
16. Loosen the belt pulley from the engine shaft. Use a
puller if it is necessary. Refer to
Servicing tools on
page 16
.
17. Remove the 4 engine fixtures.
18. Lift the engine to remove it.
19. Install the engine in the opposite sequence.
Note: The belt pulley groove must align with the
output shaft key. Make sure that the spacer pipe (A)
and shaft key (B) are attached to the engine shaft.
Put grease on the engine shaft when you attach the
engine belt pulley.
9.2.2 To do a check of the engine oil level
1. Park the product on level ground and stop the
engine.
2. Open the engine cover.
30 - Repair instructions 855 - 002 - 28.03.2019
To Next Page
Loading...
