a) For model R 318X.
b) For model R 316TX.
11. Lightly lubricate the rubber seal on the new oil filter
with new oil.
12. Turn the oil filter clockwise by hand until the rubber
seal is in position, then tighten a half turn more.
13. Fill with new oil as given in
Technical data on page
66
.
14. Start the engine and let it operate at idle speed for 3
minutes.
15. Stop the engine and make sure that there are no
leaks.
16. Do a check of the oil level and fill if it is necessary.
9.2.4 To do a check of the transmission oil level
Note: Do the transmission oil check when the
transmission is cool.
1. Put the product on a horizontal surface.
2. Remove the screws, one on each side, and remove
the transmission cover.
3. Make sure that the oil level in the transmission oil
tank is between the 2 horizontal lines on the tank.
4. Fill with oil if the oil level is below the lower line, but
do not fill above the top line. Refer to
Technical data
on page 66
for recommended oil.
9.2.5 To clean and replace the air filter on
Kawasaki
1. Open the engine cover.
2. Loosen the 2 knobs that hold the air filter cover and
remove it.
32 - Repair instructions 855 - 002 - 28.03.2019
To Next Page
Loading...
