Husqvarna R112C5 - Cutting Deck Removal; Removing the Cutting Deck (Steps 4-7); Removing the Cutting Deck (Steps 8-13)

4. Put the lift lever for the cutting deck in operation
position.
5. Release the clip and remove the drive belt cover.
6. Disengage the spring for the drive belt to loosen the
drive belt tension.
7. Remove the drive belt.
8. For R112C, R112C5: Hold the cutting deck with 2
hands and pull it out. Lift the cutting deck and put it
against the product or a wall.
9. For R115C: Hold the cutting deck with 2 hands and
pull it out until it stops.
10. Lift the equipment frame lock to vertical position.
WARNING: The lock mechanism can
cause injury to fingers if you do not
operate it carefully. Put the equipment
frame lock in full vertical position.
11. Remove the pin to disconnect the stay from the
cutting deck.
12. Hold the cutting deck with 2 hands and pull it out.
13. Lift the cutting deck and put it against the product or
a wall.
12
516 - 001 - 26.01.2018